Roco and Fleischmann WLANmaus Z21 Mode D'emploi page 80

Menus
3.5.3 Select "LANGUAGE VERSION" to find out which language version is in use.
To cancel, press the STOP or OK-key. You will then be returned to the initial
"LANGUAGE VERSION" level.
3.5.4 "BATTERY VOLTAGE" displays the current battery voltage in volts (V).
For example: "4.12V".
To cancel, press the STOP or OK-key. You will then be returned to the initial
"BATTERY VOLTAGE" level.
3.5.5 "CONTROL UNIT" displays information about the connected control unit, provided that it is a
product of the Z21 family or a smartRail.
Options: "HARDWARE TYPE", "VERSION" or "CURRENT".
To select an option, use the arrow keys and confirm with the OK-key.
"HARDWARE TYPE": shows you the type of hardware installed.
For example: "Z21 LIGHT". In the case of a z21start, its activation status is also displayed
via the additional words "LOCKED" or "UNLOCKED".
"VERSION": shows you the version number of the firmware.
"CURRENT": shows you the current power consumption in real time.
For example: "0.05A".
To cancel, press the STOP or OK-key. You will then be returned to the initial
"CONTROL UNIT" level.
▪ Note: If the control unit is not recognised or is a product from a third-party manufacturer,
the scrolling text "UNKNOWN" appears when you access this submenu.
3.6 "WLAN"
3.6.1 „SSID"
Selection or entering of the SSID of the router that is to be connected to the WLANmaus.
"SEARCH": displays max. 8 of the strongest networks in the environment of the WLANmaus.
The desired network is selected by pressing the OK-key.
"ENTER": if the desired network should not be displayed with "SEARCH", you can enter it
manually here. The SSID that is in current use is also displayed here (please refer to the expla-
nations on the entering of characters, page7).
▪ Note: The selection must be confirmed with the OK- key. On selection of "SEARCH"; the
word "WAIT" will appear in the display whilst the environment is searched for available net-
works. This process may take a few seconds. After conclusion of the search, a maximum of 8
networks are listed depending on availability and sorted according to their signal strength,
whereby the first network shown accords with the highest signal strength found. You can
browse through the list of networks using the arrow keys.
3.6.2 „PASSWORD"
This is where the password is to be entered. Pay great attention to the exact use of capitals/
small letters, special characters and spaces! The entered password is stored in the WLANmaus
after you have confirmed it with the
menu (please refer to the explanations on the entering of characters, page 7).
3.6.3 „Z21-IP-ADDRESS"
The IP address of the Z21 can be entered here, this means „Where does the mouse send its
commands to?" The pre-setting of the WLANmaus is conform with the pre-setting in your
80
80
8010813920_II_2022.indd 80 8010813920_II_2022.indd 80
OK-key. The password is no longer displayed in the
09.02.2022 09:17:28 09.02.2022 09:17:28