Roco and Fleischmann WLANmaus Z21 Mode D'emploi page 74

1.4 "SEARCH"
This could be one of the most important functions of your WLANmaus You can use this menu item to
assign a locomotive address to the corresponding locomotive in the library.
Simply enter a locomotive address using the function keys and the WLANmaus will find the corre-
sponding locomotive in the library.
– Press the OK-key to confirm the entry. The WLANmaus returns directly to locomotive mode and
display the assigned locomotive.
If the WLANmaus does not find the corresponding locomotive for the address, "LOCO NOT FOUND"
appears in the display. You can use the STOP-key or OK-key to return to the start level "SEARCH."
1.5 "SEND"
1.6 "RECEIVE"
You require both of these menu items when you wish to transfer the locomotive library from one
WLANmaus to another WLANmaus (or several WLANmaus devices). To do so, you set the transmitting
WLANmaus to "SEND" and the other WLANmaus or WLANmaus devices to "RECEIVE." The receiver
units must be activated first.
You start the transmission by pressing the OK-key on the transmitting WLANmaus. When the trans-
fer is complete, the receiver WLANmaus/ WLANmaus devises is/are in library mode, the transmitting
WLANmaus is at the start level "SEND."
1.7 "MODE"
You can either control a locomotive from library mode as set in the factory or simply using the locomo-
tive address. You can select which of the settings you prefer using this menu item.
You select the respective mode using one of the arrow keys. The modes are displayed in scrolling text.
▪ To confirm, press the OK-key. You return to the start level "MODE."
74
74
8010813920_II_2022.indd 74 8010813920_II_2022.indd 74
Menus
09.02.2022 09:17:18 09.02.2022 09:17:18