Roco and Fleischmann WLANmaus Z21 Mode D'emploi page 65

Input
...
/
Activating and deactivating routes
1. Switch the WLANmaus into route mode (see previous chapter).
2. You can call up the various routes using the arrow keys.
3. By pressing the
briefly and the route turnouts will be switched. You can recognise activated routes through the
following turnout symbol:
The route will remain activated until it is either deleted, edited or one turnout in the route is indivi-
dually switched.
If a turnout which is saved in a route is switched independently of the route, then the route will
be deactivated. You can recognise deactivated routes through the following turnout symbol:
However, the route will be reactivated again automatically if the turnout is switched again into the
position saved in the route.
If the route is activated via the OK key, the switched turnout(s) will switch back into the position
saved in the route.
4. You can get back into locomotive mode using the
The WLANmaus is switched by creating a new route mode or calling one up. After that, you no
longer switch from locomotive to turnout mode when you press the
up the route mode. You can revert this change by pressing the
in route mode.
8010813920_II_2022.indd 65 8010813920_II_2022.indd 65
Display
You can enter the next turnout after pressing the
/
"arrow keys". Carry out input in the same way as in the previous
two steps.
OK key, you can activate a route. The turnout symbol in the display will flash
.
Operation - Driving and Switching
Note
Enter the number of the first route
turnout, here as an example turnout
number 5, set to branch line.
After entering "5", the "5" will flash
until you have determined the next
step of the route..
Determine the direction of the route
using the arrow keys (straight on
with the left arrow key, branch line
right arrow key). The turnout number
will cease to flash and "0" will be en-
tered for the free turnouts.
Note: If you only press the
without having entered a route, then
the turnout will not be saved.
Once you have processed all the turn-
outs, press the OK key. You will then
be returned to the start image.
You can get into locomotive mode by
pressing the key.
key.
key, but instead call
and keys simultaneously
OK key
key and the
.
65
09.02.2022 09:16:44 09.02.2022 09:16:44