Roco and Fleischmann WLANmaus Z21 Mode D'emploi page 79

3.3.5 You can use "FACTORY RESET" to reset your WLANmaus completely to the original status.
Any entries made are deleted.
With the items listed above, all you have to do is press the OK-key. You are then
automatically returned to the "RESET" menu item.
3.3.6 „You will not normally have to calibrate the WLANmaus as this is performed on delivery.
However, in the event of extreme temperature variations, the controller may need to be re-
adjusted, e.g. if a locomotive travels in the zero position. To do so, use the "CALIBRATION"
menu and proceed as follows:
▪ The first screen you see is the "START?" screen. To confirm, press the OK-key.
"LEFT" appears on the display screen.
▪ Turn the controller to the left as far as it will go. To confirm, press the
"MIDDLE" appears on the display screen.
▪ Turn the controller to the middle (zero position) and confirm by pressing the
"RIGHT" appears on the display screen.
▪
Turn the controller to the right as far as it will go. Once you have confirmed by pressing the
OK-key, you return to the start level "RESET".
If the WLANmaus no longer responds to keyboard commands, use the following key combination to
reset the unit to the factory setting:
Press -key and MENU-key simultaneously and press OK-key briefly. The text "RESET ALL?" is dis-
played. Confirm the reset with OK-key and the WLANmaus is reset and restarted.
3.4 "STOPMODE"
In the event of an emergency, press the STOP-key during drive mode to trigger an immediate emer-
gency stop. You determine the exact effect of the emergency stop in menu item "STOPMODE."
Use this menu option to define whether pressing the STOP-key disconnects the entire .system from the
mains power supply ("DISABLE VOLTAGE") or whether this only stops the locomotives ("EMERGENCY
STOP"). Use the arrow keys to make a selection and confirm with OK-key.
Factory setting: DISABLE VOLTAGE
You can still trigger a "selective emergency stop" that only affects the selected locomotive in
spite of this setting.
Please note: should the radio signal be interrupted, a STOP can no longer be triggered using the
WLANmaus STOP-key . This is now only possible using the OK-key. of your Z21.
3.5 "INFOS"
This menu item provides comprehensive information about the software and battery voltage of your
WLANmaus as well as the connected control centre.
3.5.1 Select "MOUSE VERSION" to find out the software version of your WLANmaus
To cancel, press the STOP or OK-key. You will then be returned to the initial
"MOUSE VERSION" level.
3.5.2 Select "WLAN VERSION" to find out the software version of the wireless module.
To cancel, press the STOP or OK-key. You will then be returned to the initial
"WLAN VERSION" level.
8010813920_II_2022.indd 79 8010813920_II_2022.indd 79
Menus
OK-key.
OK-key.
79
09.02.2022 09:17:27 09.02.2022 09:17:27