Roco and Fleischmann WLANmaus Z21 Mode D'emploi page 69

There are two ways to exit the menu level:
▪
Press the STOP-key. You may need to do this several times depending on the submenu which you are
currently in. Each time you press STOP-key you go back one level.
▪
Press the MENU-key (alone or together with the
locomotive and turnout mode.
Basic information about using the menu functions and programming:
▪
When navigating within the menu level (always from top to bottom in the overview on the following
pages), use one of the two arrow keys to access the individual menus.
▪
Press the OK-key to open a menu item (always sideways in this overview) to make entries or changes.
▪
If the display depicts one of the four main menus, you can also simply open the desired menu item by
pressing the corresponding number with the function keys.
▪
Pressing the STOP-key always returns you to the previous level..
To safeguard against erroneously opening menus or incorrect entries, etc.: Pressing the STOP-key
does not confirm an entry made into a menu item.
A locomotive cannot be controlled while the WLANmaus is in menu mode.
Only one locomotive at a time may be read out and/or programmed.
All of the menus of the WLANmaus can be found in the large overview on the next two pages.
8010813920_II_2022.indd 69 8010813920_II_2022.indd 69
-key) to exit all levels immediately and return to
Menus
69
09.02.2022 09:16:51 09.02.2022 09:16:51