Stop Auto Scan; Delete A Nuisance Channel; Restore Channels To The Scan List - Motorola Commercial Série Manuel De L'utilisateur

STOP AUTO SCAN

Select a channel that has not been
preprogrammed for Auto Scan by your dealer/
programmer.

DELETE A NUISANCE CHANNEL

Note: Your dealer/programmer must prepro-
If a channel continually generates unwanted
calls or noise (a "nuisance" channel), you can
temporarily remove it from the scan list:
1 While the radio is on the Nuisance Channel,
press the preprogrammed Nuisance
Channel Delete button until you hear a tone.
2 Release the Nuisance Channel Delete
button. The nuisance channel is deleted.
Note:
28
English
gram a button to access this feature
(see page 18).
You cannot temporarily delete the
channel that has been prepro-
grammed by your dealer/program-
mer as your designated scan
channel, a priority channel, or the
last remaining channel in the scan
list.

Restore Channels to the Scan List

1 Power off the radio. Once the radio is powered
on again, the deleted nuisance channels are
restored to the scan list.
or
– –
1 Press the preprogrammed Scan button to stop
the scan.
2 Press the preprogrammed Scan button again
to start scanning again. The Deleted Nuisance
Channels are restored to the scan list.
or
– –
1 Select a channel that has not been
preprogrammed for scan by your dealer /
programmer to stop Scan. Once you return to
the original channel, the deleted nuisance
channels are restored to the scan list.