Stop System Scan; Start Auto Scan G; Stop Auto Scan - Motorola CP200XLS Manuel De L'utilisateur

L M
3 or until
J
4 to select
The display shows the current scan status.
L M
5 or until
J
6 to select the current setting.

STOP SYSTEM SCAN

Press the preprogrammed Scan button to stop
System Scan (see page 17).
– or –
J
1 to enter menu mode.
L M
2 or until
J
3 to select
The display shows the current scan status.
SYS SCAN 4
SYS SCAN 5
SCAN ON
Note:

START AUTO SCAN G

Auto Scan automatically starts scanning once
a channel/talkgroup with Auto Scan enabled is
selected.
SYS SCAN Select a channel/talkgroup that has been
preprogrammed for Auto Scan by your dealer/
SYS SCAN
programmer.

STOP AUTO SCAN

Select a channel/talkgroup that has not been
preprogrammed for Auto Scan by your dealer/
programmer.
• The Gsymbol disappears from the display.
L M
or until
SCAN OFF
J
to select the current setting.
• The Gsymbol disappears from the dis-
play.
Your dealer/programmer can preprogram
your radio when exiting System Scan to
automatically revert to the last scan channel/
talkgroup that had activity on it or to
automatically revert to the channel/talkgroup
where scan was initiated.
33
English