Disconnecting From Bluetooth Devices; Clearing Bluetooth Pairing; Turning Scan On Or Off - Motorola WAVE TLK 100i Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

MN007302A01-AC
Chapter 12 : Menu
12.8.4

Disconnecting from Bluetooth Devices

Procedure:
1 When the Bluetooth accessory goes out of range or turn off, it will be disconnected from the
radio automatically.
The radio sounds an indication tone after disconnected from the Bluetooth accessory.
2 The radio attempts to reconnect to the same Bluetooth accessory within a reconnect timer.
12.8.5

Clearing Bluetooth Pairing

Procedure:
1 Press the Power/Info button until you see the Bluetooth icon.
2 Scroll through the bluetooth list using Talkgroup/Contact List Scroll Rocker or Volume Up
and Volume Down buttons until the right bluetooth is displayed.
3 On the device "friendly" name, press and hold the Menu/Programmable button to clear the
pairing.
If clearing the bluetooth pairing successfully, a positive tone sounds.
If clearing an unpaired device, a negative tone sounds.
12.9
Scan
This feature allows your radio to cycle through the programmed scan list for the current channel
looking for voice activity.
When in the scan mode, the system preempts an ongoing low-priority talkgroup call. Your radio
unmutes to the high-priority talkgroup call. You respond to the active talkgroup when you press the
PTT button during the programmed period (hang time) of an ongoing call from your scan list.
Pressing the PTT button when the radio is not in a call, causes the radio to start a call on the last
selected talkgroup.
NOTE: If the DND mode is enabled during the scan mode, your radio prioritizes the DND mode.
12.9.1

Turning Scan On or Off

NOTE: Depending on the configuration of your radio, press or press and hold the Menu/
Programmable button to directly access the feature. Else, manually enter the feature with the
following procedure.
Procedure:
1 Press the Menu/Programmable button.
2 Locate the Scan icon.
3 To turn on Scan, press the Volume Up button. To turn off, press the Volume Down button.
If Scan is on, the following occurs:
36

Publicité

Chapitres

Table des Matières
loading

Table des Matières