Motorola Commercial Série Manuel De L'utilisateur page 40

Restore Channels to the Scan List
Power off the radio then turn it on. – OR – Press the preprogrammed Scan button
to stop the scan. The Deleted Nuisance Channels are restored to the scan list.
– OR – Select a channel that has not been preprogrammed by your dealer/
programmer to stop Scan. Once you return to the original channel, the deleted
nuisance channels are restored to the scan list.
LED Indicators
LED State/Color
Radio Call
Red Transmitting
Flashing Red Receiving
Flashing Red Channel Busy
Scan
Flashing Green Scanning for activity
Call Alert
Flashing Yellow Indicates receiving a Call Alert
Selective Call
Flashing Yellow Indicates receiving a Selective Call
Sticky Monitor/Open Squelch
Yellow While monitoring
Indication
Audio Indicators for Programmable Buttons
Programmable Buttons
Scan
Power Level
Squelch
Repeater/Talkaround
VOX
Silent Monitor/Open Squelch
Option Board
Escalert
You can check battery charge status if your dealer has preprogrammed
one of the programmable buttons. Hold down the preprogrammed Bat-
tery Indicator button. The charge status is shown on the display.
Battery Level
Good
Sufficient
Low
Very Low
Positive Negative
Indicator Tone Indicator Tone
Start Stop
High Low
Tight Normal
Does not use Uses repeater
repeater
Enabled Disabled
– Enabled
Enabled Disabled
Enabled Disabled
LED Indicator
Green
Yellow
Flashing Red
None