Parts Included - Balanced Body Allegro Reformer Manuel D'instructions

How to Install the Allegro

PARTS INCLUDED:

Item No. Part Number Description
1 618-030
2 618-031
3 618-021
4 ALL0091
5 614-020
6 GEN8320
7 GEN7321
8 GEN7325
9 GEN9021
10 GEN9282
2
3
5
8
9
TOOLS NEEDED (NOT INCLUDED):
» Two 1/2" or adjustable wrenches
» One 7/16" wrench
Allegro Leg, A
Allegro Leg, B
Leg Nut Plate
Rubber Pad, Leg, Allegro
Wheel Bracket, Allegro Ext
Leg
Allen Key, 3/16" Ball Point
Screw, Button Head, 5/16-18
x 3/4"
Screw, 1/4-20 x 3/4"
Nut, Nylock, 1/4-20
Allen Key 5/32" Short Arm
Legs Kit
®
1. If you have a Tower Of Power installed, remove the ropes,
loosen the 4 tower knobs, and remove the tower.
Qty
2. Using the included shorter allen wrench, remove the 4 screws
2
holding the head end cover plates and riser pins in place. Set
2
them aside to be re-installed later. See Figure A.
2
4
2
1
12
4
4
1
Figure A
1
3. Attach all springs to keep the carriage stationary. Remove
ropes, shoulder rests, and risers. Place the footbar (if installed)
in its lowest position and check that all pins are locked so that
the footbar is secure. Then, with the help of a friend, lift the
4
Allegro from both ends and carefully turn it upside down and
6
set it on the floor. You may want to place a pad or other floor
10
protection beneath the Reformer.
7
13