Unpacking, Assembly And Initial System Check - DePuy Mitek FMS SOLO Mode D'emploi

Unpacking, Assembly and Initial
System Check
Unpacking:
Verify that all items on packing list match
the products you have received (verify serial
numbers and references). Damage should be
reported immediately to your DePuy Mitek Sales
Representative or contact DePuy Mitek Customer
Service in the USA at +1-800-382-4682, select
Option 2. Save all packaging material, as they
will be required to ship products in the event of a
product return.
Once box is open, remove, read, and follow the
Instructions for Use. To remove the FMS SOLO
console, place hands on both sides of console,
until you can securely grasp the underside.
Carefully remove the console from the box and
place it on a level and sturdy surface.
Assembly:
- C onnect the power cord to the power connection
(14).
- C onnect the foot pedal to the foot pedal
connection (16) on the back of the pump.
Note: numbers in ( ), refer to diagram in section 1.5.
109076-KIM Rev B.indd 7
Initial System Check:
- S witch the I/O switch (14) on "I" .
- T urn the device ON by pressing the POWER (4)
pad.
- P ress on all pads. An audible tone should be
heard for each pad pressed, except for Pressure
Cycle, (Pad 8) (Pressure Cycle is inactive until
the pump is primed.)
7
9/26/12 4:02 PM