Pressure Cycle Mode - DePuy Mitek FMS SOLO Mode D'emploi

4.6. Pressure Cycle mode.

This function increases the pressure by 60% for a two minute cycle. The pressure then returns
automatically to its original setting. The pressure cycle mode is activated when bleeding occurs. The
pressure cycle can be canceled by pressing the Pressure Cycle mode again.
The pressure cycle mode is
activated either by pressing
the "Pressure" pad...
109076-KIM Rev B.indd 26
... or using the remote
control Ref. 288051, which is
connected on the front panel
of the pump...
The remote control
is not autoclavable and not
soakable. A sterile disposable
remote control cover must be
used Ref. 281087.
26
... or by pressing on the red
foot pedal Ref. 284171, which
is connected on the rear panel
of the pump (see on page 14,
n° 16).
9/26/12 4:02 PM