Cleaning And Care; Overheating Protection Circuit - Unold 86430 Notice D'utilisation

CLEANING AND CARE

1. Never use any abrasive scouring agents, steel
wool, metal objects, hot cleaning agents or
disinfectants.
2. To clean the filter, open the filter cover. Remove
the filter and clean it with warm water that must
not be hotter than 30°C.
3. Allow the filter to dry completely, before you
reinsert it. Then carefully close the filter cover.
4. You can remove dust in the appliance if you
carefully hold a vacuum cleaner against the air
outlet grille or air inlet grille.
5. Store the fan heater in a dry, safe place so that it
is protected from dust, shocks, heat and moisture.

OVERHEATING PROTECTION CIRCUIT

1. The appliance is equipped with an overheating protection circuit that
switches the appliance off when it is heated over 70° C.
2. If the overheating protection circuit has been tripped, switch the appliance
off, unplug the plug from the electrical outlet and let the appliance cool for
at least 30 minutes.
3. Eliminate the cause of the overheating, (e.g. excessive dust in the appliance,
air outlet grille is covered) and start up the appliance again.
4. If after eliminating the cause, you still cannot switch the appliance back
on, or if the overheating protection circuit switches on without an apparent
reason, contact our customer service organisation.
28
Switch off the appliance.
Unplug the plug from the electrical outlet.
Allow the appliance to cool completely.
Copyright UNOLD AG | www.unold.de