Cleaning And Care; Overheating Protection Circuit - Unold CARRY Notice D'utilisation

active and cleans the air flowing
through the appliance.
24. To switch off the appliance, press
the "On/Off" button, switch off
the appliance via the ON/OFF
switch and unplug the mains
plug.

CLEANING AND CARE

Switch off the appliance. To
switch off the appliance, press
the "On/Off" button, switch off
the appliance via the ON/OFF
switch and unplug the mains
plug.
Allow the appliance to cool
completely.
1. Never use any abrasive scouring
agents, steel wool, metal objects,
hot cleaning agents or disinfec-
tants.
2. You can remove dust in the
appliance if you carefully hold a
vacuum cleaner against the air
inlet and outlet grille.

OVERHEATING PROTECTION CIRCUIT

1. The appliance is equipped with a
double overheating protection cir-
cuit that switches the appliance
off when it is heated over 70° C.
2. If the overheating protection cir-
cuit has been tripped, switch the
appliance off, unplug the plug
from the electrical outlet and let
the appliance cool for at least 10
minutes.
3. Eliminate the cause of the over-
heating, (e.g. excessive dust in
the appliance, air outlet grille is
24
Be aware that the appliance
can become very hot - danger
of burns! Particularly ensure
that children are kept away
from the appliance.
3. To clean the filter, open the filter
cover. Remove the filter and clean
it with warm water that must not
be hotter than 30°C, (do not put
it in a washing machine!)
4. Allow the filter to dry completely,
before reinserting it. Then care-
fully close the filter cover.
5. Store the fan heater in a dry, safe
place so that it is protected from
dust, shocks, heat and moisture.
covered) and start up the appli-
ance again.
4. If after eliminating the cause, you
still cannot switch the appliance
back on, or if the overheating pro-
tection circuit switches on wit-
hout an apparent reason, contact
our customer service organisation.