Disposal And Recycling; Troubleshooting - Scheppach DECO-XL Traduction Du Manuel D'origine

Defective electrical connection cables
Electrical connection cables often suffer insulation
damage.
Possible causes are:
• Pinch points when connection cables are run
through window or door gaps.
• Kinks resulting from incorrect attachment or laying
of the connection cable.
• Cuts resulting from running over the connecting
cable.
• Insulation damage resulting from forcefully pulling
out of the wall socket.
• Cracks through aging of insulation.
Such defective electrical connection cables must not
be used as the insulation damage makes them ex-
tremely hazardous.
Check electrical connection cables regularly for dam-
age. Make sure the cable is disconnected from the
mains when checking.
Electrical connection cables must comply with the
regulations applicable in your country.
Single-phase motor
• The mains voltage must coincide with the voltage
specified on the motor's rating plate.
• Extension cables up to a length of 25 m must have
a cross-section of 1.5 mm2, and beyond 25 m at
least 2.5 mm2.
• The connection to the mains must be protected
with a 16 A slow-acting fuse.
Only a qualified electrician is permitted to connect
the machine and complete repairs on its electrical
Fault
Saw blades break
Motor does not function
Vibration
NOTE: The saw vibrates slightly
when the motor is running in normal
operation.
Saw blade swings out
Holders not aligned straight
22 GB
Possible causes
Tension incorrectly set
Load to great
Incorrect saw blade variety
Workpiece not fed straight
Mains Gable faulty
Motor faulty
Saw incorrectely installed
Unsuitable underlay
The work bench is not screwed
down or is on the motor
The motor is not secured
Holders not aligned
equipment.
In the event of enquiries please specify the following
data:
• Motor manufacturer
• Type of current of the motor
• Data recorded on the machine's rating plate
• Data recorded on the switch's rating plate
If a motor has to be returned, it must always be dis-
patched with the complete driving unit and switch.

12. Disposal and recycling

The equipment is supplied in packaging to prevent
it from being damaged in transit. The raw materials
in this packaging can be reused or recycled. Never
place batteries in your household refuse, in fire or in
water. Batteries should be collected, recycled or dis-
posed of by environment-friendly means. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.

13. Troubleshooting

Warning: In the interests of operational safety, al-
ways switch off the saw and remove the mains plug
before carrying out maintenance work.
Action
Set the correct tension
Feed the workpiece more slowly
Use the correct saw blades
Avoid exerting pressure from the side
Change faulty parts
Call customer service. Do not attempt to
repair the motor yourself as this should be
carried out by trained personnel.
Refer to the instructions given earlier in
this manual for information on installing
the saw
The heavier the work bench is,the less the
vibration. A bench made from ply wood
always vibrates more than one made from
solid wood. Select the work bench best
suited to your working conditions
Tighten the locking lever
Securely screw the motor in place
Losen the screws with which the holders
are fastenedto the arm. Align the holders
so that they are perpendicular to each
other and retighten the screws.