User Menu; Menu Fuel Management; Power; Auger Calibration - Bio Bronpi Elsa Instructions D'installation, D'utilisation Et D'entretien

10.4.

USER MENU

In order to access the user menu, it is necessary to press once the key SET of the remote control.
The following table describes the structure of the user menu of the stove. The table explains the options available for the user.
In order to move inside the submenus, it is necessary to press the keys
submenu. In order to modify the values, use the keys
necessary to press the key ESC.
MENU
Combustion Management
Heating Management
Chrono
Monitor
Manual Load
Settings
System Menu
10.4.1.

MENU FUEL MANAGEMENT

This menu modifies the combustion parameters. It has the following submenus:
10.4.1.1.

POWER

It is possible to modify the power of the stove according to the values available: power 1, 2, 3, 4, 5 or A (A=
automatic combustion). After 5 seconds, the new value will be saved and the display will return to the normal
state (see drawing D60).

Auger Calibration

Max: 7
Set: 0
Min: -7
D61
rpm) set for the smoke extractor. After 5 seconds, the new value will be saved and the display will return to the
normal state.
Consider that a higher speed of the smoke extractor means a higher capacity to discharge the smoke but
also a higher air entry into the combustion chamber (bigger flame). If you observe that the stove is not burning
properly or the mix air/fuel is not appropriate, try to modify the speed of the smoke extractor.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
to increase or decrease the value. In order to exit from the submenu, it is
Power
Auger Calibration
Fan Calibration
Heating Power
Store Room Thermostat
Modality
Chrono Program
Thermostat Management
Radio Standby
Time and Date
Radio Test
Cange Code
Set Contrast
Key Tone
Language
10.4.1.2. AUGER CALIBRATION
Press key SET. The screen will show the value (Set). With the keys
possible to increase or reduce the value. The original value introduced is 0
and it goes from -7 ... to ...+7 (see drawing D61). Note that each numerical
value modified is equal to modify proportionally in all the powers a 2% of the
load time value (in seconds) set for the auger. After 5 seconds, the new value
will be saved and the display will return to the normal state.
Consider that a higher pellet load means a higher thermal power of the stove
and, therefore, a higher fuel consumption. If you observe that the stove is not
burning properly or the mix air/fuel is not appropriate, try to modify the fuel
load.

10.4.1.3. SMOKE FAN CALIBRATION

Press for a while the key SET. The screen will show the value (Set). With the
keys , it is possible to increase or reduce the value. The original value
introduced is 0 and it goes from -7 ... to ...+7.
-7 ... 0 ...+7 (see drawing D62). Note that each numerical value modified is
equal to modify proportionally in all the powers a 5% of the speed value (in
and confirm with the key SET in order to enter into each
S
Disable / Dayly / Weekly / Weekend
Dayly / Weekly / Weekend
Enabled / Disabled
Enable
Enabled / Disabled
39
SUBMENU
Power
Pot: 3
, it is
Fan Calibration
Max: 7
Set: 0
Min: -7
D60
D62
ELSA