Seasonal Stoppages - Bio Bronpi Elsa Instructions D'installation, D'utilisation Et D'entretien

Once the upper part is cleaned, it is necessary to clean the smoke register in the lower part of the stove. In order to do this,
it is necessary to open the door of the stove and, later, follow the next steps:
- Extract the register cover by unscrewing the screws. See drawing D19
- Clean the ashes and the soot placed in the register.
- Clean the blades and the case of the extractor. Extract the extractor if necessary. See drawing D20.
- Replace the pieces and check the hermeticism of the register.
In this model of stove, there are other two cleaning registers placed on the sides of the stove:
- In order to clean them, it is necessary to remove the side chambers of the stove.
- These registers are placed on each side of the combustion chamber (see drawing D22 and 23).
In both cases, follow the next steps:
- Extract the register cover by unscrewing the screws. See drawing D24
- Clean the ashes and the soot placed in the register.
- Replace the pieces and check the hermeticism of the register.
8.8

SEASONAL STOPPAGES

If the stove will not be used for a long time it is convenient to keep the fuel tank empty, such as the screw-type conveyor to avoid the fuel
compacting. Clean the stove and the smoke duct, removing the ashes and other residues, close the stove door. It is recommended to clean
the chimney at least once a year. Meanwhile, check the seals because if they are not in good condition (they do not adjust to the door), they
do not guarantee the proper operation of the stove! For this reason, it would be necessary to change them. If there is humidity in the place
where the stove is installed, put absorbent salts inside the equipment. Protect the internal parts with neutral vaseline in order to keep the
appearance overtime.
It is possible to disconnect the stove from the electrical network, but remember that if it is going to be disconnected for a long time, when you
connect it again, it will show the time 00:00 will appear blinking, and you will need to introduce again the values of date and time.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
D17
D20 D21
D22
D18
D23
31
D19
D24
ELSA