Correction Of The Smoke Extractor Speed; Set Up Date And Time; User Mode; Ignition Of The Stove - Bio Bronpi Elsa Instructions D'installation, D'utilisation Et D'entretien

9.3.4.

CORRECTION OF THE SMOKE EXTRACTOR SPEED

It is necessary to press for a while key P4 and, later, press again P4 for a while.
The lower display shows the message "UEnt" and the upper display shows the
value introduced. By using keys P2 and P4, it is possible to increase or decrease
the value introduced. The original value introduced is 0 and it goes from -7 ... to
...+7. Note that each numerical value modified is equal to modify proportionally in
all the powers a 5% of the speed value (in rpm) set for the smoke extractor. After 5
seconds, the new value will be saved and the display will return to the normal state.
Consider that a higher speed of the smoke extractor means a higher capacity
to discharge the smoke but also a higher air entry into the combustion chamber
(bigger flame). If you observe that the stove is not burning properly or the mix air/
fuel is not appropriate, try to modify the speed of the smoke extractor (see drawing
D29).
9.3.5.

SET UP DATE AND TIME

It is necessary to press simultaneously during 3 seconds keys P3 and P4. Later,
press key P2 until the display D1 shows the word "oroL" and confirm the submenu
with key P3. Press again key P3 to modify. The value selected (hours, minutes, day,
etc) flashes. Modify the value with keys P2 and P4. Press key P3 in order to modify
the rest of parameters and press again P3 to save the value set (see drawing D30).
1 3 : 0 0
ESC
GS
9.4.1.

IGNITION OF THE STOVE

In order to ignite the stove, simply press the key P1 during a few seconds. Firstly, the stove carries out an initial check-up and continues the
ignition process. After this, the display shows different steps of the ignition process (2, 3 and 5) (see drawing D32, D33,D34 and D35).
The maximum duration of the ignition phase is 20 minutes. If after this time there is not flame, the stove will automatically activate the alarm
state and the display will show the alarm message "Er12".
ESC
GS W
9.4.2.

STOVE IN OPERATION

Once certain smoke temperature has been reached, the hot air fan starts working.
Once the ignition phase has been finished properly, the stove enters into "Work"
mode which represents the normal operating mode (see drawing D36).
1 3 : 0 0
ESC
 22
GS
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
9.4.
The normal operation of the display/receiver is described below.
Before switching on the display, the stove state is showed in drawing D31. It only
23
shows the room temperature and the current time.
W
D31
ESC
GS
D31
The display shows
the time, the working
power and the room
temperature.
9.4.3.
Press key P2 or P4 and the display D4 will start flashing. By pressing keys P2 or
P4, it is possible to select the temperature desired for the room (see drawing D37).
W
After 5 seconds, the new value will be saved and the display will return to the
normal state.
D37
ESC
ESC

USER MODE

ESC
W GS
D32
ESC

ADJUSTMENT OF THE ROOM TEMPERATURE

34
0
UEN
GS W
1 3 : 0 0
FR
GS W
ESC
W GS
D33
1 3 : 0 0
3 20
GS W
D29
D30
W
D34
D36
ELSA