Correction Of The Smoke Extractor Speed; Set Up Date And Time; Programming The Stove - Bio Bronpi ELSA Instructions D'installation, D'utilisation Et D'entretien

9.3.4.

CORRECTION OF THE SMOKE EXTRACTOR SPEED

It is necessary to press for a while key P4 and, later, press again P4 for a while.
The lower display shows the message "UEnt" and the upper display shows the
value introduced. By using keys P2 and P4, it is possible to increase or decrease
the value introduced. The original value introduced is 0 and it goes from -7 ... to
...+7. Note that each numerical value modified is equal to modify proportionally in
all the powers a 5% of the speed value (in rpm) set for the smoke extractor. After 5
seconds, the new value will be saved and the display will return to the normal state.
Consider that a higher speed of the smoke extractor means a higher capacity
to discharge the smoke but also a higher air entry into the combustion chamber
(bigger flame). If you observe that the stove is not burning properly or the mix air/
fuel is not appropriate, try to modify the speed of the smoke extractor (see drawing
D36).
9.3.5.

SET UP DATE AND TIME

It is necessary to press simultaneously during 3 seconds keys P3 and P4. Later,
press key P2 until the display D1 shows the word "oroL" and confirm the submenu
with key P3. Press again key P3 to modify. The value selected (hours, minutes, day,
etc) flashes. Modify the value with keys P2 and P4. Press key P3 in order to modify
the rest of parameters and press again P3 to save the value set (see drawing D37).
C r o n
ESC
GS
The word "ModE" appears on the display. This menu allows you to select the operation mode of the thermostat and activate it. You can only
choose one programming mode. You must confirm the mode chose with the P3 key.
Gior: Daily Programming
Sett: Weekly Programming
FiSE: Weekend programming
OFF: Disable all programmings
- Menu Programming Time Bands
The word "ProG" appears in the display. It consists of 3 submenus corresponding to the 3 programming modes allowed:
- Daily: Allows you to configure 3 schedules for each day of the week.
- Weekly: Allows you to configure 3 schedules per day, same for each day of the week.
- Weekend: It allows you to configure 3 schedules per day, differentiating between the programming from Monday to Friday and the one
of Saturdays and Sundays.
Daily mode: the day of the week
Weekly mode: Monday-Sunday
Weekend mode: Monday-Friday
For the On time, the segment in the lower part of the display D2 is
turned on
For the Off time, the segment on the top of the display D2 is turned
on
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
9.3.6.
This menu is used to set timing on the startup and shutdown sequences. Press the
keys P3 and P4 simultaneously for 3 seconds. Then press the P2 key until the word
"Cron" appears on the display D1, then confirm the submenu with the P3 key (see
drawing D38).
W
It consists of two submenus:
D38
-
MODE
VIEWINGS
Saturday-Sunday
ESC
ESC

PROGRAMMING THE STOVE

Menu Chrono Enabled
40
0
UEN
GS W
1 3 : 0 0
FR
GS W
LED
DISPLAY
M o
M S
M F
S S
- - - -
1 M o
I
- - - -
1 M o
I
ELSA AND PAULA
D36
D37