Power Set-Up; The Room Temperature Reaches The Temperature Fixed By The User; Burner Cleaning; Switching Off The Stove - Bio Bronpi ELSA Instructions D'installation, D'utilisation Et D'entretien

1 3 : 0 0
ESC
5 0
GS
9.4.5. THE ROOM TEMPERATURE REACHES THE TEMPERATURE FIXED
BY THE USER
When the room temperature reaches the value fixed by the user or the smoke
temperature reaches a value too high, automatically, the stove starts working at a
lower power. The stove modulates. See drawing D55.
1 3 : 0 0
ESC
PCLr
GS
D56
9.4.7.

SWITCHING OFF THE STOVE

In order to switch-off the stove, simply press key P1 during a few seconds. Once the stove is turned off, it starts the final cleaning phase in
which the pellet feeder stops and the smoke extractor and the tangential fan start working at maximum speed. This cleaning phase will not
stop until the stove reaches the appropriate cooling temperature (see drawings D57 and D58). Meanwhile, the following screens will appear:
ESC
9.4.8.

REIGNITION OF THE STOVE

Once the stove is turned off, it is not possible to reignite again until a safety time has elapsed and the stove is cold enough. If you try to ignite
the stove again and it is not cold enough, the display will show the information on drawing D59 but the stove will not ignite again until it is
cold enough. Then, it will turn on normally.
9.4.9.

STOVE SWITCHED OFF

Drawing D60 shows the information of the display when the stove is switched off.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
9.4.4.
Press key P3 and the display D2 will start flashing. By pressing the key P3, it is
possible to modify the power of the stove according to the values available: power
1, 2, 3, 4, 5 or A (A= automatic combustion). After 5 seconds, the new value will be
W
saved and the display will return to the normal state (see drawing D54).
D54
9.4.6.
During the normal operation of the stove, there are automatic cleanins of the burner
each time set by Bronpi.
This cleaning lasts 150 seconds and consists in cleaning the rests of pellet placed
in the burner in order to make easier the operation of the stove. When this happens,
W
the display will show the following messages (see drawing D56):
O F F
3 
GS W

POWER SET-UP

ESC

BURNER CLEANING

1 3 : 0 0
ESC
3 
D57
43
1 3 : 0 0
od
GS W
GS W
D58
ELSA AND PAULA
D55