Burner Cleaning; Switching Off The Stove; Reignition Of The Stove; Stove Switched Off - Bio Bronpi Elsa Instructions D'installation, D'utilisation Et D'entretien

10.3.6.

BURNER CLEANING

During the normal operation of the stove, there are automatic cleanins of the burner each time set by Bronpi.
This cleaning lasts a few seconds seconds and consists in cleaning the rests of pellet placed in the burner
in order to make easier the operation of the stove. When this happens, the display will show the following
Mon 13:22
Extinguish
18º
22º
º
D55
10.3.9.

STOVE SWITCHED OFF

Drawing D58 shows the information of the display when the stove is turned off.
10.3.10.

INTERCONNECTION WITH THE STOVE

If the interconnection between the remote control and the stove is lost, the display will show the message "no
signal". It would be necessary to approach the remote control to the stove so that the signal is reestablished
and the display will show the corresponding information (see drawing D59).
No signal
D59
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
messages (see drawing D54):

10.3.7. SWITCHING OFF THE STOVE

In order to turn off the stove, simply press the key
Once the stove is turned off, it starts the final cleaning phase in which the
pellet feeder stops and the smoke extractor and the tangential fan start
working at maximum speed. This cleaning phase will not stop until the stove
reaches the appropriate cooling temperature (see drawing D55).

10.3.8. REIGNITION OF THE STOVE

Once the stove is turned off, it is not possible to reignite again until a safety
time has elapsed and the stove is cold enough. If you try to ignite the stove,
the display will show the messages on drawing D56 and D57.
Ignition in
Progress
Please wait
D56
during a few seconds.
Ignition
Failed
38
Mon 13:22
Cleaning on
18º
22º
º
D54
D57
Mon 13:22
OFF
18º
22º
º
D58
ELSA