Ventilation System; Servicing And Care; Burner Cleaning; Cleaning The Ash Pan - Bio Bronpi Elsa Instructions D'installation, D'utilisation Et D'entretien

7.

VENTILATION SYSTEM

This model has the possibility to active or deactivate the convection turbine of the stove. By using the remote control, you can activate the
operation of the turbine. In this way, the stove will heat the air through the own radiation of the stove and the forced convection of the turbine.
In the event that you choose to deactivate the operation of the turbine, the heating of the air will be generated by the radiation of the stove
and, in this case, by natural convection.
In order to active or deactive the operation of the turbine, check section 10.4.2.1 of this manual "heating power".
8.

SERVICING AND CARE

The maintenance operations guarantee a proper working of the product over its lifetime. Not making these maintenance operations will affect
the security of the product.
8.1

BURNER CLEANING

The burner cleaning must be made daily (see drawing D12).
• Remove the burner from its place and clean the holes.
• Use a vacuum to get rid of the ashes in the burner. You can buy a
Bronpi vacuum-cleaner in the same Bronpi distributor where you bought
your stove.
8.2

CLEANING THE ASH PAN

The ash pan should be emptied when necessary. The stove should not be
operated without having the ash pan inside (see drawing D13).
D14
When the pellet is burnt slowly, it produces tar deposits and other organic vapours that combined with the humidity to create soot (creosote).
An excessive accumulation of soot may cause problems in the smoke outlet and the flue may catch fire if not maintained.
The cleaning of the stove chimney should only be made when the equipment is cold. A chimney sweep should perform this task and, at the
same time, examine the smoke duct (it is recommended to write down the dates of every cleaning and keep a register of them).
8.5

CLEANING THE GLASS

IMPORTANT:
Clean the glass only when it is cold in order to avoid possible explosion. You can use specific products. You can find Bronpi
vitro ceramic-cleaning product at the same Bronpi distributor where you bought your stove (see drawing D15).
BREAKAGE OF GLASSES. The glasses, as they are vitro ceramic, resist until 750ºC and they are not subject to thermal
shocks. The breakage can only be caused by mechanical shocks (crashes or violent closing of the door, etc). Therefore, its
replacement is not included in the warranty.
8.6.

EXTERNAL CLEANING

Do not clean the external surface of the stove with water or abrasive products because they may damage the
stove. Use a feather duster or a rag a bit wet.
8.7.

CLEANING THE REGISTERS

In order to maintain the validity of the warranty period, it is compulsory that the registers of the stove are cleaned
by a technician authorized by Bronpi Calefacción, who shall leave a record in writing of the intervention made.
It consists of cleaning the ash registers of the stove as well as the smoke passway.
First, it is necessary to clean completely the inside of the combustion chamber. It is not necessary to extract the
inside vermiculite plate. Rub dirty surfaces with a steel brush.
It is also necessary to clean the chamber of the heat exchangers because the soot accumulated in the upper
part complicates the smoke circulation. In order to access this part, it is necessary to remove the top of the
stove and, then, follow the next steps:
- Extract the register cover by unscrewing the four screws. Drawing D16 and D17.
- Clean the ashes placed in the upper part. Drawing D18.
- Replace the pieces and check the hermeticism of the register.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
8.3 SEALS OF THE COMBUSTION CHAMBER AND
GLASS FIBRE
The seals guarantee stove hermetic nature and, thus, a proper
performance (see drawing D14).
It is necessary to check them regularly; if they are worn-out
or damaged they should be replaced immediately. You can
find ceramic cord and self-adhesive fibre at the same Bronpi
distributor where you bought your stove.
These operations should be done exclusively by an authorised
technician.
An authorised technician must do the maintenance at least once a year.
8.4

CLEANING THE CHIMNEY

30
D12
D13
D15
D16
ELSA