Menu Monitor; Menu Manual Auger Load; Menu Approach; Submenu Thermostat Management - Bio Bronpi Elsa Instructions D'installation, D'utilisation Et D'entretien

10.4.4.

MENU MONITOR

This menu shows some technical parameters of the stove. By pressing the keys
D68 and D69):
Monitor
Exhaust T.
123ºC
Stove Room T.
23ºC
Air Flux
430 cm/s
D67
10.4.5.

MENU MANUAL AUGER LOAD

If during the operation of the stove, it runs out of fuel, in order to avoid any problem during the next ignition,
it is possible to carry out a preload of pellet of the auger during a maximum time of 600 seconds when the
Thermostat Management
Enabled
Disabled
D71
battery consumption. If you press the key SET, the screen shows "enabled" and if you press again the key
SET, the remote control deactivates and turns off. In order to activate again the remote control, press
twice the key (see drawing D72)
Standby
Radio
Enable
D72
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
Monitor
Fan Speed
1300 rpm
Auger
2.2 s
Work Time
1630 h
D68
stove is turned off and cold and the door is closed. In order to start the load,
access the submenu "manual load" by pressing the key SET. Select the
option ON and confirm with SET. The smoke extractor will start working during
the load for safety reasons. In order to interrupt the load, press the key ESC.
Before proceeding with a new ignition of the stove, do not forget to empty the
burner in order to avoid a dangerous situation (see drawing D70).

10.4.6. MENU APPROACH

10.4.6.1. SUBMENU THERMOSTAT MANAGEMENT

In this submenu, it is possible to activate or deactivate the function of the thermostat of the remote control.
If the thermostat of the remote control is activated, the operation of the stove will depend on the temperature
detected by the remote control, no matter what its position is. It is possible to deactivate this function so that
the stove depends on the temperature of the room probe of the stove. In this way, it detects the temperature
of the room where the stove is placed. (see drawing D71)
10.4.6.2.

SUBMENU STANDBY RADIO

This menu allows to turn off completely the remote control. This reduces the
10.4.6.3.

SUBMENU DATE AND TIME

Set up date and time It is necessary to introduce the value for each field
(hours, minutes, year, month, day) by pressing SET (see drawing D73). The
electronic card has a lithium battery that allows the autonomy of the clock to
be from 3 to 5 years.
10.4.6.4.

SUBMENU TEST RADIO

This menu allows to verify the connection between the remote control and
the electronic card. This test allows to verify the level of pollution of the electromagnetic waves. The remote
control is continuosly sending and receiving data from the card, checking right and wrong transmissions. The
quality of the signal depends on the number of wrong transmissions. In order to interrupt the test, press ESC.
10.4.6.5.

SUBMENU CHANGE CODE

The change of the code allows to link the remote control with a particular electronic card. In this way, the
remote control is only linked with one stove. This allows the existence of different stoves in a particular area. In
order to change the code, it is necessary to follow the next steps:
- Choose the code from the list that appears in the remote control, for example, 998. But do not press
SET. This will be done later (see drawing D75).
, the following screens will appear (see drawing D67,
Monitor
Ignitions
13
Product Code
-------------
-------------
-------------
D69
42
Manual Load
ON
OFF
Time and Date
11:46
and
Wednesday
08/04/2015
D70
D73
ELSA