Ventilation System; Channeling System; Stoves Mod. Lola, Eva, Coral, Abril-Ex, Carmen-Ex And Models Rita, Zoe, Noa And Princesa With Optional Channeling Kit; How To Install The Optional Channeling Kit (Only For Models Rita, Zoe, Noa And Princesa) - Bio Bronpi Air Série Instructions D'installation, D'utilisation Et D'entretien

7

VENTILATION SYSTEM

All models of stoves incorporate a convection turbine as standard for the heating of the environment, the operation of this turbine is in line with
the working power of the stove, so that with the stove on, the turbine will always remain working.
On the other hand, the model Abril has the possibility to activate or deactivate the operation of the main convection turbine of the stove. From
the display you can deactivate the turbine operation. This way, the stove will perform the heating of the environment through the radiation of
the stove itself and by natural convection.
If it is chosen to activate the operation of the turbine, the heating of the environment is also produced by the radiation of the stove and, in this
case, by forced convection.
To activate or deactivate turbine operation, refer to the section of this manual 10.4.10 Menu 9: "Fan mode".
8

CHANNELING SYSTEM

Below is detailed the operation of the air distribution system to other adjacent or upper rooms of the stoves including this system.
8.1 STOVES MOD. LOLA, EVA, CORAL, ABRIL-EX, CARMEN-EX AND MODELS RITA, ZOE, NOA AND PRINCESA WITH
OPTIONAL CHANNELING KIT
This models includes on the rear side one or two exits (depends on the model) with a 80 mm diameter
corresponding with the forced air output channelling system to heat other adjacent or upper rooms. The
regulation of the channelling system is made by the electronic system of the stove, therefore you can
choose the operation of each one of the pipes and the power level desired to each fan independently. To
do this you have to gain access to menu 1 and choose the fan activation and the working power (see
drawing D12).
Menú 01
VENT-2 1
D13
8.2

HOW TO INSTALL THE OPTIONAL CHANNELING KIT (ONLY FOR MODELS RITA, ZOE, NOA AND PRINCESA)

If you have purchased an optional channeling kit consisting of a fan with the connector and the interconnection cable with the electrical
board, you should consider the following steps for a correct installation. (see drawing D14)
- First, you have to remove the side chambers of the stove to access the inside of it.
- Then place the connector and the turbine in the right position and fix it by positioning and tightening the screws supplied.
- Finally, connect the existing cable in the turbine, with the electronic plate of the stove, to the connector CN6 "V2 / PO". Do not forget to
cut off the electrical power of the stove, before making this connection.
9

SERVICING AND CARE

The maintenance operations guarantee a proper working of the product over its lifetime. Not making these maintenance operations will affect
the security of the product.
9.1

BURNER CLEANING

The burner cleaning must be made daily (see drawing D15).
• Remove the burner from its place and clean the holes.
• Use a vacuum to get rid of the ashes in the burner. You can buy
a Bronpi vacuum-cleaner in the same Bronpi distributor where you
bought your stove.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
NOTE: Please note that if you've purchased an Eva-Nc model this
model is not ductable, then this menu is visible but is not operational.
In the models Rita, Zoe, Noa, Princesa, Carmen and Abril, it is only
possible to modify the speed of the fan number 2 because they only
have one channeling fan (see drawing D13).
29
D12
Menu 01
1
FAN-2
FAN-3 A
D14
D15
AIR SERIES