Charge The Battery; Set Time/Date - Bosch FSA 450 Instructions D'emploi

FSA 450
...6. Getting started
1. On the Analyzer Utilities/Setup screen
choose the option Select Language.
Installed and available languages appear
in a list box.
2. Select the name of the desired language.
(Deutsch = German)
3. Choose Select.
i
After you have selected a language, the
tester displays that language until a
different one is selected.
4. If the desired
selected, the desired language group can-
not be selected (see
6.2.2

Charge the battery

1. Connect the tester to a 12 VDC power
source such as the vehicle battery or the
12-volt AC/DC power supply.
2. Select Start Battery Charging from the
Analyzer Utilities/Tools/Charge
screen to start battery charging.
3. Let the FSA 450 complete its battery
charge cycle every time the battery is
charged; this will extend the life of the
battery pack.
It takes approximately 20 minutes to fast
charge the battery pack to 85% of full charge,
and approximately 2 hours to top off the
battery pack to 100% charged. In order for the
battery to charge, the external power supply
voltage needs to be between 9 and 16 volts
DC.
i
The power button illuminates green when
the battery is charging and turns red when
the state of charge is low.
6.2.3

Set time/date

1. Touch the Analyzer Utilities/Setup/Set
Date and Time button, bringing up the Set
Date/ Set Time menu.
Robert Bosch GmbH
language cannot be
Chapter 5.2).
Battery
2. Touch the month and you will notice that
fonts start to blink on and off.
3. Touch the < > to move forward or
backward one month at a time, or you can
touch the « » to make larger jumps forward
or backward.
All the settings in the Date/Time function
follow the same procedure.
4. Touch the Save button to save the settings
to memory. Touching the Revert button
sets the Time/Date function back to the
original setting when the unit was powered
up.
5. Once you have set the date and time,
press the EXIT keypad button to return to
the Setup menu.
6.2.4 Touch screen calibration
The touch screen calibration may have
changed during shipment. If you are experi-
encing difficulty selecting touch screen but-
tons with the stylus, you may need to re-
calibrate the touch screen. This procedure is
on the analyzer and can be displayed by
selecting Analyzer Utilities from the Main
menu and selecting the following sequence of
submenus: Tools / Calibration / Touch Screen
Calibration.
6.2.5 Powering the tester
• Internal battery pack:
Used to power the FSA 450 when
operating the 4 Channel Oscilloscope or
when a power source is not available.
When powered by the internal battery
pack, the analyzer is completely isolated
from the circuit being measured. This
method of powering the analyzer is
recommended because it provides the
greatest protection against incorrect lead
connection as well as a "noise free" power
source for accurate measurements.
EN | 29
1 689 979 945 (28.07.2006)