Bosch FSA 450 Instructions D'emploi page 23

FSA 450
A. CONTENTS
i
Before operating the Bosch test device,
read all instructions and information in the
separate operating manual "Important
notes and safety instructions for Bosch test
devices" (1 689 979 922) carefully and
comply with them at all times.
The engine must be at a standstill and the
ignition switched off when Bosch test
devices are being connected in the engine
area or to the ignition system.
Robert Bosch GmbH
1. Safety instructions............................ 24
1.1 Important notes ................................... 24
1.2 Safety instructions .............................. 24
2. Use ..................................................... 25
3. Delivery specifications ..................... 26
4. Description of device........................ 26
4.1 FSA 450 top controls .......................... 26
4.2 FSA 450 bottom controls .................... 27
5. Software update and installation of
new languages ................................... 27
5.1 Basic requirements ............................. 27
5.2 Installation........................................... 27
6. Getting started .................................. 28
6.1 Structure ............................................. 28
6.2 Initial start-up ...................................... 28
7. Operation ........................................... 30
7.1 Switching the FSA 450 on/off.............. 30
7.2 FSA 450 start screen system software 30
7.3 FSA 450 system screen layouts ......... 30
7.4 Operating the FSA system software ... 31
8. Special accessories parts ................ 32
9. Service parts/parts subject to wear. 32
10. Hardware ........................................... 33
10.1 Communication ports ......................... 33
10.2 Signal and data I/O ports.................... 33
10.3 Sampling system ................................ 34
10.4 Memory/RAM ..................................... 34
10.5 User interface ..................................... 34
10.6 Power specifications........................... 34
10.7 Accuracy specifications ...................... 35
10.8 Speaker .............................................. 35
10.9 Trigger clamp...................................... 35
10.10 Special accessories.......................... 36
11. Software............................................. 36
11.1 Digital Volt Ohm Meter (DVOM).......... 36
11.2 4-channel oscilloscope ....................... 36
11.3 Graphing multimeter ........................... 38
11.4 Secondary quick check....................... 39
11.5 Primary ignition................................... 39
11.6 Secondary ignition .............................. 39
11.7 Compatibility (EMC)............................ 40
11.8 Vacuum waveform .............................. 40
11.9 Cranking kV test ................................. 40
11.10 Help menus ...................................... 40
EN | 23
1 689 979 945 (28.07.2006)