Compatibility (Emc); Vacuum Waveform; Cranking Kv Test; Help Menus - Bosch FSA 450 Instructions D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 43
40 | EN
...11.
Software
i
The coloring of the connecting cables does
not correspond to the polarity of the
individual measurement signals, but is
intended as a connecting aid only.
In the example stated above (see
this means that the red cable has to be con-
nected to cylinders 1, 4, and 3, the black
cable to cylinders 6, 2 and 5 (System has two
separate measurement channels). The sig-
nals are then displayed correctly by the sys-
tem on screen.
!
Please note connecting polarity of trigger
clamp (see dots on trigger clamp).

11.7 Compatibility (EMC)

This product is a Class A product in accor-
dance with EN 61 326.
i
This product can cause radio interference
in the home; in this case the operator may
be
asked
to
measures.

11.8 Vacuum waveform

11.8.1 Display functions
Vacuum
Waveform—crankshaft
based display of AC vacuum
Barchart—percent vacuum per cylinder
with
live,
minimum,
average values
Engine RPM and DC vacuum
11.8.2 Measurement functions
Engine Analyzer Display Range: 0.1 inHg/
div to 2 inHg/div
Selectable Ranges:
-
0.8 inHg - 16 inHg
Selectable Trigger Cylinder
Voltage
Offset:
between bottom and top of grid
1 689 979 945 (28.07.2006)
Figure
implement
appropriate
angle
maximum,
and
channels
adjustable
11.8.3 Record and storage functions
Record and Playback movie of displayed
screens
User selectable record time
Save and Recall display screens
8)

11.9 Cranking kV test

DI (DIST. IGN.), EI (DISTRIBUTORLESS),
and CNP (COIL-NEAR-PLUG) ignition
system support
Measure of the secondary ignition firing
voltage during crank cycle
Provides simple Pass/Fail results based
on Threshold voltages identified by the
user
Selectable 2-12 kVolt threshold setting for
Pass/Fail Identification
Barchart
measured

11.10 Help menus

Displays information pertaining to present
display screen functionality

11.11 Battery charging feature

Displays message when battery state is
low
Prevents from overcharging
Automatically
preventing excessive battery drain

11.12 Transfer of bitmaps to PC

Ability to transfer bitmaps to PC using File
Transfer Utility (FTU)
-
-
-
-
-
Data is sent with a Date/Time stamp so
new files do not overwrite existing files.
display
of
live
shuts
Oscilloscope
Ignition Primary/Secondary
Vacuum Waveform
Graphing Multimeter
Cranking kV Test
Robert Bosch GmbH
FSA 450
kV
values
down
tester,

Publicité

Table des Matières
loading

Table des Matières