User Instructions; Important Notes; Safety Instructions; Electromagnetic Compatibility (Emc) - Bosch FSA 740 Instructions D'emploi

2.

User instructions

2.1

Important notes

Important notes on the agreement pertaining to copy-
right, liability and warranty, about the user group and
obligation on the part of the contractor, are available in
the separate instructions entitled "Important notes and
safety instructions" on Bosch test equipment . These are
to be read thoroughly before using, connecting and op-
erating the product and they must be observed .
2.2

Safety instructions

All safety instructions are available in the separate in-
structions "Important notes and safety instructions" on
Bosch test equipment . These are to be read thoroughly
before using, connecting and operating the product and
they must be observed .
2.�

Electromagnetic compatibility (EMC)

This product is a product of Class A as under EN 55 022 .
i
This product can cause radio interference in the
home; in this case the operator may be asked to
implement appropriate measures .
2.4

Disposal

This product is subject to European guide-
lines 2002/96/EG (WEEE).
Old electrical and electronic devices, including
cables and accessories or batteries must be
disposed of separate to household waste.
¶
Please use the return and collection sys-
tems in place for disposal in your area .
¶
Damage to the environment and hazards to
personal health are prevented by properly
disposing of old equipment .
Bosch Diagnostics
user instructions | FSA 740 | 17
3.

Product description

�.1

use

The FSA 740 vehicle system analysis is a modular test
device used for test engineering purposes in automotive
workshops . FSA 740 records vehicle-specific signals
and routes them via the USB interface to a Windows-
based PC . The FSA system software is installed on the
PC . The FSA System software contains the following
functions:
R
Vehicle identification .
R
Settings .
R
Vehicle system analysis with
$
Test steps (testing of gasoline and diesel engines)
$
URI .
$
Signal generator (e .g . for testing sensors) .
$
Component test (testing of vehicle components) .
$
Characteristic recorder .
$
Multipurpose oscilloscope .
$
Ignition oscilloscope, primary .
$
Ignition oscilloscope, secondary .
Measurement curves which have been judged good
can be saved in the measuring system as comparison
curves . These can then be used to assess the measure-
ment results . FSA 740 has also been designed to be
networked with other ASA workshop network systems .
The KTS modules enables you to perform control unit
diagnosis via the ESI[tronic]
extended to form an exhaust gas measuring device (see
chapter 3 .4) .
i
To use the vehicle-specific test instructions
vehicle-specific target data
sions to the component testing, a CompacSoft[plus]
subscription has to be taken out .
These functions also require a release. The release is performed
*)
with the DSA. The procedure is described in the DSA Online
Help.
| 17 en
. FSA 740 can also be
*)
, the
*)
as well as future exten-
*)
1 689 979 895 | 2008-02-25