Initial Start-Up; Structure; Before Starting Up For The First Time; Language Selection In Windows - Bosch FSA 740 Instructions D'emploi

en 20 | FSA 740 | Initial start-up
4.

Initial start-up

4.1

Structure

1. Remove the packaging and the transport locks on all
parts delivered .
Connect the sensors to the specified slots in the
2.
measuring unit (see Fig . 3) . Only connect current
clamp 30 A and 1000 A as well as adapter line
1 684 465 513 if necessary .
Insert the printer into the trolley (Fig . 1; item 9) .
3.
4. Plug in power cord and the USB connecting cable to
the printer . Both cables are provided ready for con-
nection in the trolley .
i
The printer cartridges can only be used when the
printer is switched on .
4.2

Before starting up for the first time

The voltage supply is provided via the lighting mains .
In the factory, FSA 740 has been set to 100 V - 230 V,
50/60 Hz . Read the information on the sticker on the
side of the FSA 740 carefully .
BEA 050 has been set to 230 V in the factory . The trans-
former mains voltage must only be adjusted by author-
ized service personnel . For more information, refer to
the instructions in the BEA 050 documentation .
!
Before starting up, ensure that the voltage of the
lighting mains matches the voltage set on the
FSA 740 . If the FSA 740 is operated outdoors, we
recommend using a voltage source which is fused by
means of an FI circuit breaker .
4.�

Language selection in Windows

After switching the device on the first time, select a lan-
guage for the Windows operating system in a menu .
You cannot change this language at a later date . How-
ever, if this is necessary, contact your Bosch authorized
dealer .
4.4 Commissioning KTS 5�0, KTS 540,
KTS 570
The commissioning of the KTS module is described in
the product description 1 689 979 987 and in the On-
line Help from DDC .
1 689 979 895 | 2008-02-25
5.

Operation

5.1

Switching the FSA 740 on/off

Switch the FSA 740 on or off with the central mains
switch on the rear of the device (see Fig . 2; item 4) .
i
Before switching off the device, shut down the PC
using the Windows operating system . Wait at least
60 seconds before switching the device back on
again .
i
When operating the FSA 740, faults may occur if a
PC or other components (e .g . mouse, connecting
cables) from suppliers other than Bosch are used .
5.2

Diagnostic Software Access DSA

With DSA, you can:
R
Start Bosch applications (automatically as well) .
R
Make interface settings .
R
Select DSA and Bosch application language .
R
Install software .
R
Update customer and vehicle data .
R
Terminate Bosch applications .
You will find more information in the DSA online help .
5.�

Start screen for FSA system software

Fig. 4: Start screen after device is switched on
i
If several applications are open, the speed of the
FSA system software may be impaired .
Bosch Diagnostics