Symbols Used; Test Device; Documentation - Bosch FSA 740 Instructions D'emploi

en 16 | FSA 740 | Symbols used
1.

Symbols Used

1.1

Test device

Do not connect the test device to the vehicle
unless the ignition is switched off. Before
switching on the ignition, connect the test
device to the battery (B–) or engine ground.
Key to printed symbols:
Comply with these operating instructions and all techni-
cal documentation relating to the test device and the
components used!
1. Connect the test device to the battery (B–) or engine
ground .
2. Switch the ignition on .
1. Switch the ignition off .
2. Disconnect the test device from the battery (B–) or
engine ground .
Disposal
Waste electrical and electronic equipment,
including wires and accessories, power packs
and batteries must be separated from domes-
tic waste for disposal.
1 689 979 895 | 2008-02-25
1.2

Documentation

Pictograms linked with the key words Danger, Warning
and Caution are warnings and always indicate an imme-
diate or potential hazard to the user .
Danger
Immediate danger that could cause serious
personal injury or death.
Warning
Potentially dangerous situation that could
cause serious personal injury or death.
Caution
Potentially dangerous situation that could
cause personal injury or damage to property.
!
Important – warns of a potentially hazardous situa-
tion in which the product, the test sample or other
object in the vicinity could be damaged .
In addition to these warnings, the following symbols are
also used:
i
Info – In addition to these warnings, the following
symbols are also used .
¶
Single-step procedure – instructions for a procedure
that can be completed in just one step .
?
Intermediate result – an intermediate r esult is dis-
played during a procedure .
"
Final result – the final result is displayed at the end
of the procedure .
Bosch Diagnostics