Secondary Quick Check; Primary Ignition; Secondary Ignition - Bosch FSA 450 Instructions D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 43
FSA 450
...11.
Software

11.4 Secondary quick check

Display
of
cylinder waveforms
Single probe connection

11.5 Primary ignition

11.5.1 Display functions
Parade
Single Cylinder
Raster
Superimposed
Firing Volts Barchart
11.5.2 Measurement functions
2 ms/div to 20 ms/div (Parade)
0.2 ms/div to 2 ms/div (Single Cylinder,
Raster, and Superimposed)
Trigger position: adjustable from 0 to 100%
Engine Analyzer Display Range: 10 Volts/
div to 500 Volts/div
Selectable Ranges:
-
80 Volts - 600 Volts
Selectable Trigger Cylinder
Voltage
Offset:
between bottom and top of grid
11.5.3 Record and storage functions
Record and Playback movie of displayed
screens
User selectable record time
Save and Recall display screens

11.6 Secondary ignition

11.6.1 Display functions
Parade
Single Cylinder
Raster
Superimposed
Firing kVolts Barchart
Power/Waste Comparison (Wasted spark
ignition only)
Robert Bosch GmbH
Secondary
ignition
single
channels
adjustable
11.6.2 Measurement functions
2 ms/div to 20 ms/div (Parade and Power/
Waste Comparison)
0.2 ms/div to 2 ms/div (Single Cylinder,
Raster, and Superimposed)
Trigger position: adjustable from 0 to 100%
Engine Analyzer Display Range: 1 kVolts/
div to 50 kVolts/div
Selectable Ranges:
-
8 kVolts - 400 kVolts
Selectable Trigger Cylinder
Voltage
Offset:
between bottom and top of grid
11.6.3 Record and storage functions
Record and Playback movie of displayed
screens
User selectable record time
Save and Recall display screens
11.6.4 Electronic Ignition (DIS) Lead Hook-up
The corresponding ignition system is selected
in the Vehicle selection menu at Manual Vehi-
cle Set-up.
After you press the corresponding menu but-
ton in the Main menu, the following graphic
(shown here by way of an example with twin-
spark coils) is displayed with the connection
diagram.
This
always be observed. Selection of the correct
ignition sequence must be followed.
Fig. 8: Connection diagram
EN | 39
channels
adjustable
connection
method
must
1 689 979 945 (28.07.2006)

Publicité

Table des Matières
loading

Table des Matières