Electrical Connection - Ingersoll Rand IRN 7.5 HP Manuel D'utilisation Et D'entretien

Table des Matières

Les langues disponibles

NOTES

1 Foundation or floor must be level, and support all feet equally. If

necessary, shim or grout the fourth foot.

2 Foundation bolts should project thru nuts a minimum of 13mm

[0.50"] to allow for levelling.

3 Allow a minimum clearance of 1100mm [42"] on the front and

920mm [36"] on the top, left, right and the rear of the package for proper

air circulation and serviceability.

4 Approximate package weight: 475 KG. (1045 LBS)

NOTE

All dimensions are in millimetres (inches) unless otherwise stated.

Ensure that the correct fork lift truck slots or marked lifting points are

used whenever the machine is lifted or transported.

UNPACKING

The compressor will normally be delivered with a polythene cover.

If a knife has to be used to remove this cover ensure that the exterior

paintwork of the compressor is not damaged.

http://air.ingersollrand.com

INSTALLATION / HANDLING

Ensure that all transport and packing materials are discarded in a

manner prescribed by local codes.

DRYER INSTALLATION

Do not connect condensate drains common to other pressurised

drain lines in a closed circuit. Make sure the outflow from the

condensate drains is unimpeded. Connect the condensate piping in

such a way to ensure that sound levels are kept to a minimum during

drainage.

Ensure that all condensate is disposed of in a responsible manner, in

accordance with local norms concerning environmental protection.

The ambient air around the dryer and compressor must not contain

solid or gaseous contaminants. All compressed and condensed gases

can generate acids or chemical products which may damage the

compressor or components inside the dryer.

Take particular care with sulphur, ammonia, chlorine and installations

in marine environments. For further advice or assistance consult your

local Ingersoll Rand representative.