Replacing The Batteries; Removing The Batteries - Assa Abloy KESO KEK Genie Knauf Manuel D'utilisateur

KESO KEK Genie Knob
2.5

Replacing the batteries

No authorisation or event data you have saved is lost when you replace the battery. Such data is
stored in a non-volatile memory. The clock (depending on the system) will continue to operate,
provided battery power is not interrupted for more than 90 seconds. If supply from the battery is
interrupted for more than 90 seconds, the clock must be reset using the KESO management
software or the KESO KEK Programmer PPG V2.
2.5.1

Removing the batteries

Steps A -E
The battery is removed as described in steps A to E below: The individual steps are shown in the
photos on the left-hand side. Remove the battery step by step as indicated in the instructions.
Step A
Carefully remove the knob cover using a precision screwdriver (no. 1 or 2). To
do so, carefully insert the screwdriver into the designated slot on the plastic
cover. Gently move the screw driver back and forth until the cover is detached.
Step B
Undo the securing screws using a TX20 key. Make sure you don't lose the
washer.
Step C
Now remove the metal knob casing.
Step D
You must then carefully take off the white plastic casing.
Caution:
The electronics are underneath this casing as well as the batteries
Step E
Remove the three batteries from the battery holder.
KESO AG 05/2009 Subject to change without notice Page 11 from 24 pages