Assa Abloy KESO KEK Genie Knauf Manuel D'utilisateur page 9

KESO KEK Genie Knob
2.2.5 Programming individual user keys
Programming key – user key 1 – programming key – user key 2 – programming key – etc., up to
max. 8 user keys per group
2.2.6 Deleting individual user keys
Programming key – user key – deletion key
2.2.7 Deleting all user keys in a group
Programming key – deletion key – programming key
2.3 Programming PC Version
The KESO management software serves as a basis for programming. The KESO KEK Genie Knob
Cylinder is programmed in two ways: either directly using the KESO KEK Programmer USB, or
indirectly using the KESO KEK Programmer PPG V1 and KESO KEK Programmer PPG V2.
Programming is always carried out using your locking system master data, which is included with
every KESO KEK Genie system
2.3.1 Operation of programming processes
Attention: You should always carry out programming and deletion processes with an open door
and the bolt pushed forward, so that the door cannot inadvertently fall into the lock.
KESO AG 05/2009 Subject to change without notice Page 9 from 24 pages