English - Assa Abloy KESO KEK Genie Knauf Manuel D'utilisateur

KESO KEK Genie Knob
2

English

2.1 Operation
By inserting the key, the system is activated and the key can be read. The user (end user) is forced
to do the following: insert the key to the stop. Wait for the dwell time of minimum 140 ms, until
the electronics have processed the key's data; only then turn the key and unlock. If you do not
respect the dwell time, the electronics will block and prevent the operation of the cylinder. If you
use force and the electronics have not yet unlocked the system, the micro motor may be
damaged!
2.2 Programming Home Version
2.2.1 Operation of programming processes
Attention: You should always carry out programming and deletion processes with an open door
and the bolt pushed forward, so that the door cannot inadvertently fall into the lock.
2.2.2 Management of a KESO KEK Genie Home system
As a user of a KESO KEK Genie HOME system, you are responsible for the management of your
keys. Should a master key in a KESO KEK Genie HOME Version be lost, then the entire system
must be re-programmed. In this case, please consult the source of your KESO Mechatronik.
2.2.3 Delete cylinder
Master key – deletion key – master key
2.2.4 Creating programming keys
Master key – programming key 1 – master key – programming key 2 – master key – etc. up to max.
32 programming keys
KESO AG 05/2009 Subject to change without notice Page 8 from 24 pages