Safety Instructions; Technical Data - Anslut 018354 Mode D'emploi

SAFETY INSTRUCTIONS

• Do not expose the battery to naked flames
or heat.
• The lamp and solar panel are weather
resistant, but do not immerse them in
water or any other liquid.
• Do not look directly into the lamp when it
is switched on.
• Do not use the lamp if the chimney is
damaged.
• The light sources are not replaceable. If
the lamp stops working it must be
discarded.
• Do not attempt to charge batteries with a
battery charger that is connected to the
mains, and do not attempt to run the
solar lamp from the mains.
Rechargeable batteries
IMPORTANT:
When replacing batteries – only use
rechargeable batteries.
• Always buy the correct size and type of
battery intended for this purpose.
• Remove the battery from the product if it
is not going to be used for some time.
• Recycle used batteries in accordance with
local regulations.
Symbols
Approved as per applicable
directives.
Recycle discarded product as
electrical waste.

TECHNICAL DATA

Battery
Output
Luminous flux
Protection rating
DESCRIPTION
1. Floodlight
2. Solar panel
3. Motion sensor
4. Power switch
5. Screw
6. Screw plug
7. Screw
8. Adjusting screws for floodlight angle
FIG. 1
FIG. 2
INSTALLATION
1. Make sure to put the solar panel where
it will get as much sunlight as possible.
Note that trees and buildings etc. can put
the solar panel in the shade and affect its
charging capacity.
2. Mark out where to drill the holes for
the solar panel. Check that there are no
cables or conduits under the markings.
Drill holes for the supplied plugs and
screws. Put the plugs in the drilled holes
and screw on the solar panel with the
screws.
3. For best functionality place the floodlight
at a height of no more than 2 metres
above the ground on a stable surface
that can support the weight of floodlight
and which will not move if exposed to
vibrations or wind. The floodlight must be
3.7 V / 2400 mAh Li-ion
1.8 W
1000 lm
IP44
EN
13