Safety Instructions; Technical Data - Anslut 019937 Mode D'emploi

EN

SAFETY INSTRUCTIONS

• Only intended for indoor use.
• Do not connect the light to the mains
while it is still in the pack.
• Check that all electrical and connecting
cables comply with the applicable
regulations and that they are connected
in accordance with the instructions.
• Never overload the mains. This can result
in fire or a risk of electric shock.
• Keep out of the reach of children.
• Do not store the light in a damp or very
cold/hot place, this can damage the
electronics.
• The electronics in the light are sensitive to
knocks and blows. Avoid dropping it.
• Never attempt to replace damaged power
cords yourself.
• The light source should only be replaced
by an authorised service representative or
other qualified personnel.
• The product is not dimmable.
• Make sure that no concealed cables can
be damaged during the installation.
WARNING!
New installations and extensions to existing
systems should always be carried out by
an authorised electrician. If you have the
necessary experience and knowledge
(otherwise contact an electrician), you can
replace power switches and wall sockets,
fit plugs, extension cords and light sockets.
Incorrect installation can result in fatal injury
and the risk of fire.
14
Symbols
Approved as per applicable
directives.
Only intended for indoor use.
Safety class II.
Recycle discarded product in
accordance with local regulations.

TECHNICAL DATA

Rated voltage
Output
Luminous flux
Colour temperature
Life span
Energy class
Size
INSTALLATION
See figures for installation instructions:
FIG. 1
FIG. 2
FIG. 3
FIG. 4
FIG. 5
FIG. 6
FIG. 7
230 V ~ 50 Hz
8 W
900 lm
3000 K
35000 h
L562 x W24 x H34 mm
E