Replacing The Battery - Anslut 018354 Mode D'emploi

EN
high enough to detect movement and to
disperse the light.
4. Mark out where to drill the holes for the
floodlight. Check that there are no cables
or conduits under the markings. Drill
holes for the supplied plugs and screws.
5. Put the floodlight on the screws.
6. Adjust the angle of the floodlight with the
adjuster screws (8).
USE
Before the floodlight can shine at full capacity
the solar panel must have charged the battery
in direct sunlight for 36–48 hours. Put the
switch in the 0 (OFF) position before charging.
After charging put the switch in the I (ON)
position.
NOTE:
Avoid pointing the sensor at:
• Objects that can quickly fluctuate in
temperature, e.g. ventilation openings
and air conditioning units.
• Things that move, such as treetops and
traffic.
• Only use the solar panel to charge the
batteries. Do not use any other type of
charger.
MAINTENANCE
• Check at regular intervals that the
connection between the solar panel and
the floodlight is working properly.
• Clean the solar panel regularly with a
damp cloth. This ensures optimum
capacity and battery charging.
• Never allow abrasive substances or
materials to come into contact with the
solar panel.
14

Replacing the battery

1. Unscrew the four screws holding the
battery cover in place.
2. Carefully remove the battery cover and
release the battery cable.
3. Replace the old battery with a new
rechargeable battery (3.7 V 2400 mAh
Li-ion).
4. Replace the battery cable and put the
battery pack in the floodlight.
5. Replace the battery cover and screw tight.
WARNING!
• Do not open, short-circuit or otherwise
damage batteries.
• Do not mix old and new batteries.
• Do not mix different types of batteries.
• Used batteries must not be discarded in
household waste. They must be recycled
in accordance with local regulations.