Description Of The Registers; Normal Mode - Adeunis RF ARF 18 Notice D'emploi

5.4.3 Description of the registers

Register values can be updated with the ATSn=m<cr> command and displayed with the ATSn?<cr> command.
Register values are placed in RAM. The parameters are lost if the power is cut. In order to save the registers,
you need to use the AT&W<cr> command.
Access
R/W
R/W
R/W
R/W
Other registers S8xx are available for the training process. They are described in section 6 «Training pro-
cedures».

5.4.4 Normal mode

Under normal operation, the module sends over the serial output the serial number and the key number of the
remote control received over the radio link. The format of the ASCII frame received is as follows:
• : (ASCII code 0x3A)
• the serial number is the serial number of the remote control in decimal format (1 to 8 figures).
• followed by a space (ASCII code 0x20).
• the key number is the number of the key pressed on the remote control (2 figures from 01 for key 1 to 24 for
key 24).
• CR (ASCII code 0x0D), LF (ASCII code 0x0A)
In addition, if the remote control has been paired (training process) with the receiver, outputs 1 to 4 of the recei-
ver are managed according to the key that has been pressed on the remote control. For example: output 1 for
key 1 up to output 4 for key 4. These outputs work in monostable or bistable mode depending on inputs Sel0 and
Sel1. For further details, cf section 2.4 «Remote control training process».
Gamme ARF18 UG V1.5
Registers Function
S210
S211 Data length
S212
S213 Number of stop bits
:<serial number> <Key number> <CR><LF>
Description
Serial link
Serial link speeds are as follows:
'2': 2400 bits/s
'3': 4800 bits/s
'4': 9600 bits/s (default value)
Speed
'5': 19200 bits/s
'6': 38400 bits/s
'7': 57600 bits/s
'8': 115200 bits/s
Number of bits
'7': 7 bits
'8': 8 bits (default value)
Parity
1: none (default value)
Parity
'2': even
'3': odd
Number of stop bits (serial link)
'1': 1 stop bit (default value)
'2': 2 stop bits
59