Example Of Standard Use; Training Procedure; Training A 4-Relay Receiver With A 4-Key Remote Control - Adeunis RF ARF 18 Notice D'emploi

2.5.2 Example of standard use

This paragraph presents some standard uses.
Below: 1, 4-relay receiver controlled by 1, 4-key remote control.
Below: 4, 1-relay receivers controlled by 1, 4-key remote control.
2.6.

Training procedure

2.6.1 Training a 4-relay receiver with a 4-key remote control

Global ADD/ERASE operation
1/ Select «Add/Erase» mode with SW5 ON.
2/ Select SW3 ON and SW4 OFF.
3/ Press any key on the remote control (just once - if you press twice in succession training is not recognised).
4/ Exit «Add/Erase» mode with SW5 OFF.
Two results are possible with this operation:
• Previously, this remote control did not control any of the receiver's relays: the following links are created in
the receiver's database for this remote control: key 1 controls relay 1, key 2 controls relay 2, key 3 controls
relay 3, key 4 controls relay 4. The LED flashes once.
• Previously, this remote control controlled at least one of the receiver's relays: all the links between this
remote control and the relays are erased. The LED flashes twice.
Gamme ARF18 UG V1.5 46