Procedures For Installing/Wiring Relay Receivers; 1-Relay Receiver - Adeunis Rf Arf 18 Notice D'emploi

2.4.

Procedures for installing/wiring relay receivers

The procedures described below must be followed exactly in order to ensure the correct operation and the elec-
trical safety of the ARF18 products.
The wires connected to each relay must be bound and isolated by a rilsan collar. The rilsan collar attached to the
power supply wires must also be installed in the hole drilled for the purpose in the PCB (see diagram below).
The type of power supply chosen must be identical for all the relays: SELV or mains

2.4.1 1-relay receiver

2.4.2 2-relay receiver
Gamme ARF18 UG V1.5 43