Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
AMR PULSE W-Mbus- Mode d'emploi / User guide version V1.2
2.4.6 Meter compatibility
Examples of meters tested by Adeunis RF (non-exhaustive list)
Type
Water
Gas
Electricity
Heat
3. Preparation and configuration
3.1. Dismantling the case
The product is supplied disassembled such that the lower electronic part can be accessed. This part is where the meter or meters are connected
to the screw terminals and where the configuration switches can be accessed.
Once connection of the meters has been finalised and configuration carried out, the case may be closed.
Please note: once the case has been closed, opening it is no longer possible without the risk of losing the IP67 protection index guarantee.
3.2.
Installation of the compression seal
Before connecting your meter cables to the product's screw terminals, you must insert the compression gland nut and the appropriate seal for
your configuration.
3 types of seals are supplied with the AMR PULSE: for a 5 mm diameter cable, for a 3 mm diameter cable, for 2 x 2.2 mm cables.
Assembly procedure:
1- Your meter and its
2 - Pass the cable
pulse interface.
through the compres-
sion gland nut.
Wehrle TRK-HYX / ETK-EAX
Sappel-Diehl Aquarius/Altair
Seal for 1 x 5 mm cable
Seal for 1 x 3 mm cable
3 - Pass the cable
through the compres-
107
sion gland seal
Name
Itron Flodis
Elster BK
Socomec Countis E00
Itron CF Echo II
Seal for 2 x 2.2 mm cables
90
4 - Pass the cable
through the AMR
PULSE'S case plate.
Meter type
Cyble Sensor V2
Wherle Modularis
IZAR Pulse 3 & 4 wires
Elster IN-Z63
Fludia FM250E and FM250M
27
5 - Install the O-ring
6 - Connect the ends
seal on the case plate.
of the meter cable to
the screw terminals.
Page
33
of 44
Publicité
Table des Matières
