Configuring The Amr Pulse; Closure Of The Case - Adeunis RF AMR PULSE Mode D'emploi

AMR PULSE W-Mbus- Mode d'emploi / User guide version V1.2

3.4. Configuring the AMR PULSE

Your AMR PULSE product is supplied with the following factory settings: WMBUS T1 radio mode, transmission frequency of 10 seconds.
Your AMR PULSE is configured via the combination of switches. The following settings can be changed:
• The meter type
• The pulse weight
• The transmission frequency
Note: configuration via switches lets you use 2 meters of the same type (2 water, 2 gas, ...).
CONFIGURATION TABLE:
Parameter Value
Electricity
Water
Meter type
Gas
Heat
1L / 10dm
10L / 10dm
Pulse weight
100L / 100dm
1000L / 1m
10 seconds
10 minuts
Transmission frequency
1 hour
12 hours
PLEASE NOTE: you must set your switches before activating the meters. Once the fraud wire for each of the meters has been installed and the
AMR PULSE has been started via a magnet, the configuration can no longer be changed.
If you change the switch configuration after activation, the product will transmit a switch consistency error frame. This consistency verification is
carried out every minute.

3.5. Closure of the case

Once steps 3.2, 3.3 and 3.4 have been completed, you can close the AMR PULSE's case.
Procedure:
• Make sure the seal is installed correctly on the case plate.
• Clip the electronic board to the case plate. Make sure the clip is fully engaged in the lug in the board.
SW1
ON
OFF
OFF
ON
3
/ 1Wh
3
/ 10Wh
3
/ 100Wh
3
/ 1000Wh
SW2 SW3 SW4
OFF
OFF
ON
ON
OFF OFF
OFF ON
ON OFF
ON ON
Seal
SW5 SW6
OFF OFF
OFF ON
ON OFF
ON ON
Page 35 of 44