Electromagnetic Emissions; Electromagnetic Immunity - Satelec Acteon I-Endo Dual Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 28
To avoid possible risks of electromagnetic interferences do not use other electro-
medical instruments of similar nature near
current normative electromagnetic radiation law.
This device has been tested and found to comply with the emissions requirements of
IEC 60601-1-2. These requirements provide reasonable protection against harmful
electromagnetic interference in a typical medical installation. However, high levels of
radio-frequency (RF) emissions from electrical devices, such as cellular phones, may
disrupt the performance of this device. To mitigate disruptive electromagnetic
interference, position this device away from RF transmitters and other sources of
electromagnetic energy.
Risks from electromagnetic fields: The functions of implanted systems (such as
pacemakers) can be influenced by electromagnetic fields. Patients and users must
inquire about implanted systems before using the motors and check the use. Do not
bring the motors close to the systems. Take suitable emergency precautions and
immediately react to any changes in health.

10.1 ELECTROMAGNETIC EMISSIONS

I-Endo Dual is intended for use in the electromagnetic environment specified below. The I-Endo Dual
should only be used in such an environment.
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuation/
flicker emissions
IEC 61000-3-3

10.2 ELECTROMAGNETIC IMMUNITY

I-Endo Dual is intended for use in the electromagnetic environment specified below. The I-Endo Dual
should only be used in such an environment.
Group 1
I-Endo Dual uses RF energy only for its internal function.
Therefore, its RF emissions are very low and are not likely to
cause any interference in nearby electronic equipment.
Class B
Class A
I-Endo Dual is suitable for use in all establishment including
Conforms
domestic establishments and those directly connected to the
public low-voltage power supply.
Conforms
I-Endo
Dual. The unit complies with the
22

Publicité

Table des Matières
loading

Table des Matières