Control Unit Back Panel; Control Footswitch; Technical Characteristics; Iv- Installation / First Use - Satelec Acteon I-Endo Dual Manuel D'utilisation

b. Control unit back panel
1. Main Power On/Off Switch. (Fig. 3 – 1)
2. Power Supply in. (Fig. 3 – 2)
3. Fuse. (Fig. 3 – 3)
c. Control footswitch
Activates the pre-selected maximum speed or start Forward/Reverse Movement (Fig. 4).
d. Technical characteristics
Console / micro motor / footswitch
Manufacturer By Dental
Dimensions 150 x 90 x 140 mm
(W x H x D)
Materials ASA
Micro motor 10000 rpm / Torque: 6.8
mNm
Noise < 65 dBA
Input Voltage 9 VDC
Input Current 2.5 A
Power adaptor
Manufacturer Wattac
Model BA0241CI-090-A03
Input Voltage 100 VAC – 240 VAC
Input Current 0.7A MAX
Not suitable for use in presence of flammable anesthetics or oxygen.
Conditions of use: Temp +18°C/+40°C (+64°F/+140°F) RH < 80%. Altitude restriction: 3.000m (10.000 ft)
Shipping and Storage conditions: Temp +5°C/+65°C (+41°F/+149°F) RH < 20-95% non condensing.
Life of the device: When used as prescribed = 5 years. No warranty claim may be made in the event that
the failure happen sooner or later than indicated, because of the frequency of use, sterilization and
maintenance.
IV– INSTALLATION / FIRST USE

4.1 UNPACKAGING THE DEVICE

Upon reception of the device, check for any damage caused in transit.
Contact your supplier if necessary.
Fuses 1xAT
Protection Class II
Type B
Class MD IIa rule 9 in Annex IX 93/42/EEC
Protective IP20
index console
Protective IP65
index micro
motor
Protective IP20
index
footswitch
Output 9 VDC
Voltage
Output 2500 mA
Current
Class II
10