Vi- Using The Device; Important - Satelec Acteon I-Endo Dual Manuel D'utilisation

2. RPM +/- : Sets motor rotation speed. See the following table:
RPM
3. FWD° +/-: increases or decreases the angle value in FWD from 10° to 360°, by step of 5°.
4. REV° +/-: increases or decreases the angle value in REV from 10° to 360°, by step of 5°.
VI– USING THE DEVICE

Important:

- Do not disconnect the micro-motor cord when the device is switched on and the footswitch is pressed.
- Do not engage the instrument to or disengage it from the contra-angle when the micromotor is
running.
- All accessories must be cleaned and disinfected before use.
- For your safety and that of your patient, the I-Endo Dual must not be used with accessories other than
those supplied by the manufacturer.
- Check the integrity of the device and its accessories before and after each use in order to detect any
problem.
- If necessary, do not use the device and replace any faulty component.
The I-Endo Dual is prepared for use as follows:
- Make sure that the device is connected correctly and properly insulated.
- Micromotor connection:

Connect the micro motor into the receptacle on the front of the central unit ( Right –
white – 8 Pins ). (Fig. 13)

Connect the contra-angle to the micro motor and fit an instrument (file) to the contra-
angle.
Reduction Rate
1:1 6:1
10000 1660
9000 1500
8000 1330
7000 1160
6000 1000
5600 930
5000 800
4000 650
3000 500
2400 400
2000 300
1000 150
Always check the values before use. Danger of injury for incorrect use.
Before turning on the central unit, check to see that you have completed
16:1
600
550
500
450
400
350
300
250
200
150
100
the installation of ALL COMPONENTS.
20:1 32:1
500 300
450 280
400 250
350 200
300 180
280 175
250 150
200 100
150
120
100
15