Satelec Acteon I-Endo Dual Manuel D'utilisation page 13


Contra-angle reduction rate.
Change Contra-angle reduction rate with "Ratio" button.

Type of "Autoreverse" (right)
Change type of "Autoreverse" with "SARev" button: REV Type

Programming the unit:
1. RATIO: Sets handpiece reduction ratio. See the available reduction ratio in the following
table:
1:1
2. SPEED +/-: Sets motor rotation speed. See the following table:
RPM
3. TORQUE +/-: increases or decreases the torque values (24 steps). Torque values are in Ncm
and depend on contra-angle reduction rate. See the following table:
0.5
4. REVERSE: Switch between forward and reverse motor rotation (when in reverse, console will
emit a beeping tone).
5. REV TYPE : Set the type of Auto-reverse:
A. STP – Auto-reverse "OFF":
The motor handpiece stops without reverse rotation (Fig. 9).
B. AR – Autoreverse "Standard":
When file reaches the set torque value, the motor runs reverse until the motor has been stopped. Next
start will be in Forward. NB: In use only if Torque is not set on Max (Fig. 10).
C. SAR – Auto-reverse "Special":
When file reaches the set torque value, the motor runs reverse until it has freed the file. Then the
motor runs again in forward. NB: In use only if Torque is not set on Max. (Fig. 11)
6:1
Reduction Rate
1:1 6:1
10000 1660
9000 1500
8000 1330
7000 1160
6000 1000
5600 930
5000 800
4000 650
3000 500
2400 400
2000 300
1000 150
1.0 1.5
16:1 20:1
16:1
600
550
500
450
400
350
300
250
200
150
100
Ncm
2.5
32:1
20:1 32:1
500 300
450 280
400 250
350 200
300 180
280 175
250 150
200 100
150
120
100
4.0 MAX
13