Specifications; Electromagnetic Compatibility; Electromagnetic Emissions - Satelec Acteon Mini LED AUTOFOCUS Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
H02926.S3.V4:Mise en page 1
11 – SPECIFICATIONS
Unit
Model:
Mini LED AutoFocus
Weight*:
200g
Dimensions*:
Ø24 x 210mm
Classification:
Ordinary
Type B
Continuous operation
IPX0
* Without light guide
Power adapter
Input voltage:
Frequency:
Output voltage:
Output current:
Classification:
Base station
Supply voltage:
12 VDC
Protection:
Fuse, 2A
Classification:
Continuous operation
IPX 0
Battery
Type:
Lithium-ion
Dimensions:
87 x Ø24mm
Capacity:
2,400 mAh
Optical specifications
Wavelength:
420-480 nm
Intensity:
2,200mW/cm² ±10%
(Ø7.5mm guide)
Power:
760mW ±10%
Temperatures
Operating: +10°C to +40°C
Storage: -20°C to +70°C
Humidity
Operating: 30% to 75%
Storage: 10% to 100% including condensation
06/11/2008
09:57
12 - ELECTROMAGNETIC
apart from those of any nearby devices.
Mini L.E.D. AutoFocus requires special precautions to
be taken with regard to electromagnetic compatibility.
It must be installed and prepared for use as described in
chapter 3.
Certain types of mobile telecommunication devices such
as mobile telephones are likely to interfere with the
Mini L.E.D. AutoFocus. The recommended separation
100 – 240 VAC
47 - 63Hz
distances in this paragraph must therefore be complied
12V
with.
0.6A
II
The Mini L.E.D. AutoFocus must not be used near or on
IP 40
top of another device.
If this cannot be avoided, its operation under the
conditions of use must be checked beforehand.
The use of accessories other than those specified or sold
by SATELEC as replacement parts may have the
consequence of increasing the emissions or decreasing
the immunity of the Mini L.E.D. AutoFocus.

12.1 - Electromagnetic emissions

The Mini L.E.D. AutoFocus is intended for use in the
electromagnetic environment specified in the table
below. The user and/or installer must ensure that the
Mini L.E.D. AutoFocus is used in such an environment.
Emission
Class 2M laser
RF
emission -
CISPR 11.
11
Page 11
COMPATIBILITY
Warning: The charger power cord must be kept
Compliance
Electromagnetic environment - guidance
test
Mini L.E.D. AutoFocus uses RF energy for
internal
operation.
radiofrequency emissions are very low and
are not likely to cause any interference in
nearby equipment.
Group 1
Mini L.E.D. AutoFocus is suitable for use in
Class B
all establishments, including domestic
establishments
connected to the public low voltage power
supply network that supplies buildings used
for domestic purposes.
Therefore,
its
and
those
directly

Publicité

Table des Matières
loading

Table des Matières