Operating The Simplygo Mini Device; Power Options - Philips RESPIRONICS SimplyGo Mini Mode D'emploi

Operating the SimplyGo Mini Device

Power Options

Warning: Do not use the device without the battery installed and operating�
• To run the device on battery power, make sure the battery is properly
inserted and sufficiently charged� (The battery should be fully
charged the first time you use it�)
To run the device using AC power, first make sure you have a
•
battery installed� Then, follow these steps:
1� Connect the output cable of the AC Power Supply to the
SimplyGo Mini power input connector�
2� Connect the AC Power Cord's connector into the AC power
supply�
3� Connect the AC Power Cord's plug into an AC outlet installed to
meet national or regional electrical code�
To run the device using DC power from an automobile or other
•
motorized vehicle, make sure the battery is installed� Start the vehicle
and connect one end of the DC Power Cord to the device's power
inlet and the other end into the vehicle's DC electrical outlet�
Note: DC power provided by the DC Power Supply will also charge the
battery when the device is turned off or is running on setting 1, 2, or 3�
It may not charge the battery when the device is running on setting 4
or 5� Charging status can be verified with the battery icon on the Home
Screen�
Note: Battery duration times will degrade with battery age, environmental
operating conditions, use over time, and operational condition of the
concentrator� To maximize battery life, please see the Caring for Your
Battery section of this manual� If the battery is near the end of its useful
life, you may experience battery durations of approximately two-thirds
that of a new battery�
AMSR oxygenconcentratorstore.com
SimplyGo Mini User Manual
1-877-774-9271
13