Installing The Optional Fr3 Language Card And The Battery - Philips HeartStart FR3 Manuel D'installation, D'utilisation Et De Maintenance

Setup with the optional FR3 language card and the optional FR3 data card is discussed below. See the
FR3 Instructions for Administrators CD-ROM, provided with the FR3, for a list of all accessories and
directions on setting up the FR3 with other optional accessories.

INSTALLING THE OPTIONAL FR3 LANGUAGE CARD AND THE BATTERY

The primary language is the language the FR3 uses for voice and text prompts. The FR3 can operate in
any language that is provided on the FR3 language card.
(Optional) Install the FR3
language card.
If you do not want to change the default primary language, go to the following section,
"Installing the Optional Data Card and the Battery."
To change the default primary language to a different primary language, follow these steps:
1.
2.
3.
(Optional) Re-install the
battery while holding down
the right option button.
4.
5.
Retention clip.
6.
Language card tail.
7.
8.
Battery compartment.
6
Insert the FR3 language card into the data card slot in the bottom of the FR3 battery
compartment. A label on the floor of the battery compartment shows the correct orientation for
inserting the card. A retention clip helps hold the card in the slot. The tail on the data card serves
as a visual reminder that a card is installed and aids in card removal.
Check the battery label to be sure the battery is within its install-by date. Remove the battery
from its packaging. Install the battery in the FR3 battery compartment, while holding down the right
option button. Keep the button pressed until the language selection screen is displayed. The FR3
display screen automatically provides a list of languages. There may be more than one screen of
languages.
Press the  option button to scroll to the language you want, then press the  option button to
select it. (If no selection is made within 60 seconds, the FR3 shuts down.) The new language file
automatically loads. The FR3 displays the language name and a progress bar. During language
installation, the FR3 cannot be turned off. When the language load is complete, the FR3 will
operate in the new language. Other default or previously modified configuration settings will
remain unchanged. The FR3 displays a screen for 10 seconds announcing that the setup is
complete, and reminding you to remove the language card.
Now, remove the battery and the FR3 language card. To remove the language card, grasp the data
card by its tail, press the retention clip away from the card, and pull the card out. Store the
language card in a safe place for future use or reference.
Insert an FR3 data card, if desired, in the data card slot (see following section), and reinstall the
battery. As soon as the battery is installed, the FR3 automatically runs a detailed interactive user-
initiated test. Press the buttons when directed, or the test will fail.
On completion of the test, the FR3 displays the results and then displays the main Administration
screen. If the FR3 clock has not yet been set, the FR3 will provide a reminder message. See
instructions below.
After setting the clock, press the green On/Off button to display the status screen and put the
defibrillator into standby.
Philips recommends that you relabel the green On/Off button on the FR3 with the appropriate
language decal from the set provided with the language card.